The LineTracker series of overhead line recorders are the most versatile intelligent devices available. Utility Operators, Maintenance, Designers and Planning Engineers can easily monitor the condition and performance of high voltage grids remotely or on site. With the LineTrackers built-in wireless communications, users can download information without removing the untis from the line. Installed at strategic points such as T-junctions, switches, rural feeders and substations, information is stored for local download or remote communication to existing SCADA, Outage Management Systems or Distribution Management Systems.

The values recorded include:

• Load
• Maximum Demand
• Inrush Current
• Fault Waveforms
• Protection Operation and Timing
• Voltage Status
• Conductor and Ambient Temperature
• Power Factor & Phase Angle

The comprehensive data provides accurate fault detection and identification, especially when multiple faults occur. It also highlights potential weak areas, facilitating pre-emptive maintenance before outages occur. Many Utilities use these devices as portable troubleshooting tools and permanent installations with remote reporting at a fraction of the cost of SCADA RTU installations. The solar-charged and battery-powered LineTrackers solve many user applications such as:

• Improve reliability through instantaneous, accurate multiple fault detection
• Monitor peak loads, load profiles, load balance, etc. at key points of the network, optimizing load distribution and line capacity
• Verify breaker, re-closer and fuse operations, by accurately logging fault duration
• Log switching operations, time off, time on, etc. (from which all statistical SAIDI, SAIFI, CAIDI, CAIFI, etc. figures can be determined)
• Log self clearing faults, preventing future faults through proactive maintenance
• Measure ambient and conductor temperature up to 138KV transmission lines
• Communicate via Cellular, Satellite, Radio, Ethernet and Landline. DNP3.0 compatible

Click here for LT 40/45/50 brochure

or here to link to Gridsense website for updated software, brochures and operating manuals

 Or contact us using the enquiry form with any questions you may have

PowerMonic Three-Phase Power Quality Analysers

The PowerMonic range of portable power recorders offers comprehensive and reliable monitoring of low voltage circuits. Since its introduction in 1995, the PowerMonic range has proven to be a reliable and versatile everyday instrument used worldwide by System Planners, Distribution Engineers, Electrical Engineers, Electrical Contractors, Power Quality Engineers and Maintenance Engineers alike. It supports a variety of power monitoring applications including:

• Energy Audits & Voltage Investigations
• Power Profiling and Load Studies
• Harmonic Analysis
• Power Factor Studies
• Flicker and Imbalance Monitoring

The PowerMonic Portable Power Quality Analyzers are a proven, versatile and reliable everyday instrument used by System Planners,
Distribution Engineers, Electrical Engineers, Electrical Contractors, Power Quality Engineers, and Maintenance Engineers for troubleshooting and analyzing low voltage networks.

Click here for PM45 brochure

or here to link to Gridsense website for updated software, brochures and operating manuals

 Or contact us using the enquiry form with any questions you may have

The Smart Reader Plus 3 is an 8 Channel AC Current and voltage data logger. Simply connect the current probes (which clamp around the power leads) and the voltage transducer to the data logger to begin recording. from the data collected you can even determine energy consumption (kWh).

 For more information, please click here